Microstrip Analyser

Amitec MIC Analyser MIC 10

Amitec MIC10 Features:

Amitec MIC10 Technical Specifications:

Amitec Model MIC10 uses a broadband Microwave

source working over a bandwidth from 100-2000MHz

and a receiver scanning the bandwidth. Several

modules using low loss substrate are provided with

etched surface mounted circuits. Gold plated SMA

connectors are provided on each modules for

repeatable connections. Teflon cables are provided for low loss interconnects.

* PLL stabilized signal source and receiver

operating in the frequency range of100-2000 MHz

* Vi, Vr and VSWR measurement

* Over 15 different MIC modules provided

* Windows software for graphical analysis

* Gold plated connectors

Frequency range: 100-2000 MHz PLL synthesized

Step size : 0.05, 0.1, 0.25,0.5, 1, 10MHz

Accuracy : 0.01%

Display : 16X2 Backlit LCD

Controls : Menu, Enter, Escape, Up & Down

Memory : 1000 individual frequencies can be stored

RF Level : 110 dBuV max.

Attenuator : 40dB (external)

Output Z : 50 ohms

Directional Coupler is provided with 2 GHz frequency response and 20dB directivity for antenna forward & reverse power & VSWR.

Rs232 interface for plotting with log, linear cartesian and polar plots, Vi, Vr & Return Loss plots, Multiple pattern overlay, Double cursor, Zoom, Colour editing, 1000 location editor, Absolute/Relative, 3dB/10dB band-width, Gain, Front to back, Plot rotate,

PLL Synthesized Receiver

Active Circuits:

E-Manual: Installation DVD for ease of Learning

Frequency range: 100-2000 MHz PLL synthesized

Step size : 0.05, 0.1, 0.25, 0.5, 1,10 MHz

Accuracy : 0.01%

Display : 16X2 Backlit LCD

Controls : Menu, Enter, Escape, Up & Down

Memory : 1000 individual frequencies & levels can be stored

Measurements : RF level measurement in dBuV with 0.1dB resolution

Dynamic range : 110 dB (70dB logarithmic + 40dB attenuator)

Input Z : 50 ohm

RS232 interface: To PC for plotting software

Auto mode : Interfacing with source

Microwave Amplifiers

1.MMIC amplifier

Microwave Switches

2.SPST PIN diode switch

Passive circuits:

Antennas

4.Patch Antenna transformer fed

5.Log Spiral antenna

6.Log Periodic Dipole array

3. Patch Antenna inset fed

Microwave Attenuators

7. Fixed attenuator

Impedance Matching

9.Open stub

10. Short stub

11. Mismatch

8. Matched Load

Power Dividers

11. Wilkinson w/o resistor

10.Wilkinson chip resistor type

Microwave Couplers

13. Hybrid Ring Rat race coupler

12. Coupled line coupler

Microwave Resonators

15 Half wave resonator

14.Ring Resonator